Barudan BEAT

By adminplrProducts and Services

 

Barudan BEAT User Manual

BEAT-4, BEAT 700, BEAT 800 Instructions

(C) 2009-2018 PLR Electronics

A picture of the control panel on a Barudan BEAT Embroidery Machine

 

Basics

 

Operation Keys

  • ON/OFF: To power the control power. The main breaker must be turned on first.
  • MODE: To scroll through the main menu
  • TEACH’G: To program color change sequence
  • TS: For non-thread trim machines only. Will stop the sewing 20 stitches after a stop code.
  • ORG OFFSET: To move pantograph to its alternative position.
  • M. ORG: To locate the left and right limit switches my automatically moving pantograph.
  • FLOAT: To run the pattern without sewing.
  • DRIVE: To enter drive mode. Also serves as the SET key.
  • ORG: Moves pantograph to the start position of a pattern.
  • F1-F5: Soft menu keys, for selecting options on the operations LCD screen.

 

Monogramming Keys

  • Monogram keys (lower part of keyboard) and the upper monogram LCD screen will not be discussed in this manual.

 

Bar switch or button

  • The BEAT series will have either a bar switch or START/STOP buttons.
  • BAR SWITCH LEFT: Pull bar to the left to start sewing.
  • BAR SWITCH RIGHT: Pull bar to the right to stop sewing.

 

Frame move

  • ARROW KEYS: To manually move the pantograph.

 

Load a new design

Loading from the Tape Reader or USB Reader.

1. Make sure you are not in DRIVE mode. Hold down the DRIVE key if you are in DRIVE mode.
2. Press MODE until either NEW or MEMORY appears on display.
3. Press the F1 key until the desired memory location appears.
4. If it says NEW, then that memory location is empty.
5. If it says MEMORY, that that location is used.
6. Press F2 KEY until PTR-1 appears on the screen.
7. The tape code should say B; if it does not, press the F3 KEY until it does.
8. Press DRIVE to start downloading.
9. Finished!

 

You don’t have a Tape Reader? Purchase a new USB Reader for your Barudan BEAT machine! Look at the front page of PLR Electronics!

icon carrito
 

Select a design in memory

 

1. Make sure you are not in DRIVE mode. Hold down the DRIVE key if you are in DRIVE mode.
2. Press MODE until either NEW or MEMORY appears on display.
3. Press the F1 key until the desired memory location appears.
4. Press DRIVE key.

 

Setting color change

 

1. Select a design in memory. Press the DRIVE key to enter DRIVE mode.
2. Hold down TEACH until it stops beeping.
3. The display should now say TEACH.
4. Press DRIVE.
5. You will now be at the first color change.
6. Press the F3 KEY to change colors.
7. Press DRIVE to set.
8. Repeat until done.

 

Erasing design in memory

 

1. Be sure you are not in DRIVE mode. If the DRIVE light is on, then hold down DRIVE until stops beeping.
2. Press MODE until the screen says DELETE.
3. Press the F1 KEY until the memory location to erase appears.
4. Hold down the DRIVE key until the beeping stops.
5. Done.

 

Error codes

 

A picture of the control panel on a Barudan BEAT Embroidery Machine
 

Click here for other embroidery machine manuals
 

(C) 2009-2018 PLR Electronics