Circuit board repair estimates.

By adminplrProducts and Services

We are often asked if we do circuit board repair estimates. Yes we do.
We will take a look at your circuit board, and we will let you know if it is repairable or not. We charge a flat fee of $75 for this service (based on a one-hour diagnosis). If you decide to have us handle the repair, we will waive the $75 fee. The customer is also responsible for shipping charges.

If you would like to send your board in to us for an estimate, please address it to:

PLR Electronics
ATTENTION: Circuit Board Repair Estimate
2954 SE Loop 820
Fort Worth, TX 76140

Please pack the circuit board with care and include your name and contact information inside the box, along with this completed form. As with anything valuable, we suggest you insure the item you ship and use signature confirmation.

Please call 817.988.4497 or email us at sales@plrelectronics.com for more information.

Check out our YouTube Channel to see a sample of our extensive experience.

7 thoughts on “Circuit board repair estimates.”

  1. I have a 1999 TMEX 1501… has been an excellent machine until now….. it will not trace… it will start to trace and then go all the way right past the limit and throw a code. Doesn’t keep memory

  2. HI, COULD YOU REPAIR A DU-8 DRIVER CARD, TE X AXIS CONTROL CIRCUIT ITS IN SHORT CIRCUIT , THE MOTOR IS GETTING WARM WHITOUT USE. I AM FROM MEXICO BUT I HAVE FAMILY IN USA. CAN YOU HELP ME ??

  3. hi, could you repair a Barudan BESR control panel ? The machine work but sometimes loose origin point and stop without any instruction. Need to push in off and on to continue. Fine manually the origin point
    Or do you have a barudan BESR control panel for sale ? If yes what’s a price

  4. I HAVE AN INBRO 1204 WITH LOW BATTERY SIGNAL MACHINE WILL COME ON BUT NOT OPERATE

  6. We have a Tajima C1504 machine, it is almost 5 years old. They don’t build them like they use to. It has started just stopping in the middle of a design. Needles down and you can’t push anything, it won’t do anything. You have to shut it off and when it comes back on it is on the last design you did. You have to re-enter everything. Any ideas

  7. I have a Toyota esp9000 needing the power board on the back of the machine repaired. The wiper will not fully engage. Everything else is in working order.

Comments are closed.